99-04 Jeep Grand Cherokee (WJ) Rear Bumper Tire Carrier

$30.00

The Flatland 4×4 rear bumper for the WJ is a great replacement for the factory bumper. Improved departure angle, and enhanced protection for the factory sheet metal, are some of the benefits of this bumper.

New! Rear tire carrier option now available.

The mounting solution for this bumper was built with the factory hitch receiver and gas tank skid plate in mind. Bumper can be installed without removing either accessory completely. Designed to be cut from 3/16″ steel plate.

*Special thanks to “Mark” for assistance with tire carrier measurements.*

99-04 Jeep Grand Cherokee (WJ) Front Non-Winch Bumper

$30.00
Rated 4.00 out of 5

Based on our WJ Front Winch Bumper, our non-winch design greatly increases approach angle while providing great protection for the radiator and front end.

The standard option provides maximum protection to the radiator and the slotted version increases airflow while enhancing appearance. Plans include templates for mounting brackets featuring bumper-side bolt holes for added mounting adjustability. Designed to be cut from 3/16″ and 1/4″ plate.

*NOTE* The width of the bumper shown in the “Finished Pictures” was modified to work better with the aftermarket flares. Actual width aligns with factory WJ flares.

99-04 Jeep Grand Cherokee (WJ) Front Winch Bumper

$30.00$35.00
Rated 4.33 out of 5

The Flatland 4×4 front winch bumper, for the WJ series, features a low mounting point for your winch, to maximize airflow, a winch fairlead slot, and a compact design to keep approach angles good while maintaining protection for factory components. The standard option provides maximum protection to the radiator and the slotted version increases airflow while enhancing appearance. Plans include templates for mounting brackets featuring bumper-side bolt holes for added mounting adjustability. Designed to be cut from 3/16″ and 1/4″ plate.

99-04 Jeep Grand Cherokee (WJ) Rear Bumper

$30.00

The Flatland 4×4 rear bumper for the WJ is a great replacement for the factory bumper. Improved departure angle, and enhanced protection for the factory sheet metal, are some of the benefits of this bumper.

New! Rear tire carrier option now available.

The mounting solution for this bumper was built with the factory hitch receiver and gas tank skid plate in mind. Bumper can be installed without removing either accessory completely. Designed to be cut from 3/16″ steel plate.

*Special thanks to “Mark” for assistance with tire carrier measurements.*

Flatland Window Sticker 2X10

$5.00

Our window stickers are a great way to brag about the achievement of building enhancements for your rig, not just buying off-the-shelf!

*** Only available in continental United States ***